News

Automobile Elevator Wholesalers Introduces Elevator Installation Guide

Update:18-11-2022
Summary: Automobile Elevator Wholesalers introduces the elevator installation process: 1. The basic steps of elevator install...

Automobile Elevator Wholesalers introduces the elevator installation process:
1. The basic steps of elevator installation are:
Cleaning the shaft, confirming whether there are installation conditions on site, providing temporary storage, unpacking and inspecting items, erecting, making templates, installing reference lines, installing guide rails, installing car on the top floor of machinery room equipment, hoistway mechanical equipment, tying wire ropes, and installing electrical equipment The device is equipped with hoistway cables and follow-up cables, and the whole machine is adjusted and inspected.
2. Install the drive device and release the brake of the motor
First, remove the two cotter pins, and mark the opening of the nut before removing it. After resetting, it is easy to tighten the two nuts. Be sure to turn the two nuts downward in parallel and release the brake to freely pull out the brake disc. It is also possible to install the motor brake device with a wedge, release the brake, lift the drive device with a tower, align the position from the top of the standard section, align the connecting lugs of the drive device and the car, and fix it by pins (with overload device). The elevator passes the sensor pin, the fixed groove is upward to install the fixed plate) After the suspension drive device is in place, the performance of the motor braking device is restored, and the guardrail on the car is installed.
3. Written application
If the owners of the community, building or unit have agreed to install the elevator, the entrusted implementation entity shall submit a written application to the real estate administrative department. The real estate administrative department conducts an on-site investigation and puts forward a written opinion on whether to agree to the addition of elevators. If the written opinion clearly agrees to the appendix, the implementing entity can carry out the work according to law. For special project design, the implementing body entrusts the original architectural design company or a design company with corresponding qualifications to design the elevator. After the design is completed, a design plan is issued, and the construction drawing review and filing work are carried out according to regulations.
4. When the car carries people and goods, the load should be evenly distributed. It is strictly prohibited to use the vertical button when the elevator runs to the top and bottom floors. It is strictly prohibited to use the travel limit switch to automatically collide to stop. The flute indicates that there must be adequate lighting at night. In a double-car elevator, when one car is being maintained and inspected outside the car, the other car must not run. During the operation of the elevator, the driver must not do any action that hinders the operation of the elevator.